Show simple item record

dc.contributor.authorMbulawa, Xolani Proffessor
dc.date.accessioned2008-07-18T08:06:38Z
dc.date.available2008-07-18T08:06:38Z
dc.date.issued2005
dc.identifier.other305661
dc.identifier.urihttp://hdl.handle.net/10321/314
dc.descriptionThesis (M.Tech.: Chemical Engineering)-Dept. of Chemical Engineering, Durban University of Technology, 2005 1 v. (various pagings)en_US
dc.description.abstractIn bubble-less aeration oxygen diffuses through the membrane in a molecular form and dissolves in the liquid. Oxygen is fed through the lumen side of silicone rubber tube. On the outer surface of the membrane there is a boundary layer that is created by oxygen. This then gets transported to the bulk liquid by convective transport created by water circulation through the pump. The driving force of the convective transport is due to concentration difference between the dissolved oxygen in water and oxygen saturation concentration in water at a particular temperature and pressure. The design of a membrane aerated bioreactor needs an understanding of the factors that govern oxygen mass transfer. It is necessary to know the effects of operating conditions and design configurations. Although various methods of bubble-less aeration have been reported, there still exists a lack of knowledge on the immersed membrane systems. This study is aiming at contributing to the development of an immersed membrane bioreactor using silicone rubber tubular membrane as means of providing oxygen. The secondary objective was to investigate the influence that the operating conditions and module configuration have on the system behaviour. From the experimental study, the characteristic dissolved oxygen -time curve show that there is a saturation limit equivalent to the equilibrium dissolved oxygen concentration, after which there is no increase in dissolved oxygen with time. At ambient conditions the equilibrium dissolved oxygen is approximately 8 mg/L. This is when water is in contact with air at one atmospheric pressure. At the same conditions the equilibrium dissolved oxygen concentration when water is in contact with pure oxygen is approximately 40 mg/L. This is why all the experiments were conducted from 2mg/L dissolved oxygen concentration in water, to enable enough time to reach equilibrium so as to determine mass transfer coefficient. The most important parameters that were investigated to characterise the reactor were, oxygen supply pressure, crossflow velocity, temperature and module orientation. Observations from the experimental study indicated that when the system is controlled by pressure, crossflow does not have a significant effect on mass transfer. When the system is controlled by the convective transport from the membrane surface to the bulk liquid, pressure does not have a significant effect on mass transfer. All four effects that were investigated in the study are discussed.en_US
dc.language.isoenen_US
dc.subjectSewage--Purification--Aerationen_US
dc.subjectBioreactorsen_US
dc.subjectWater--Aerationen_US
dc.subjectChemical reactorsen_US
dc.subjectBiochemical engineering--Equipment and suppliesen_US
dc.subjectMembrane reactorsen_US
dc.subjectChemical engineering--Researchen_US
dc.subjectChemical engineering--Dissertations, Academicen_US
dc.titleDevelopment and evaluation of silicone membrane as aerators for membrane bioreactorsen_US
dc.typeThesisen_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record