Please use this identifier to cite or link to this item: https://hdl.handle.net/10321/3659
Title: Influence of coarse aggregate on the shear strength of reinforced concrete beams
Authors: Jajbhay, Hoosen Ahmed 
Issue Date: 17-Dec-2020
Abstract: 
Research to accurately predict the shear capacity of reinforced concrete
beams without shear reinforcement has been ongoing since the early 20th
century. Aggregate interlock of the coarse aggregates at the shear crack
interface is one of the internal mechanisms of shear transfer and a major
contributor to the shear capacity of slender beams. It is plausible, therefore,
to investigate if the coarse aggregate itself influences the shear capacity of a
concrete beam. The influence of the type of coarse aggregate on the shear
capacity of beams without shear reinforcement was investigated in this study.
From the literature study an understanding of the properties of coarse
aggregates was gained, the internal mechanisms of shear transfer in
reinforced concrete beams without shear reinforcement were determined, and
the parameters influencing shear strength were identified. Based on this information an experimental program was designed.
Eighteen reinforced concrete beams without shear reinforcement were cast.
The beams were cast from three different types of coarse aggregates
commonly used in the Durban area, i.e., dolerite, quartzite and tillite. For each
type of coarse aggregate two variations were tested, i.e., 13 mm and 19 mm
maximum aggregate sizes. For each size of coarse aggregate, three concrete
strengths were tested. The beams were loaded in a beam press, by applying
an increasing point load offset from midspan to induce cracking on the shorter
side, until shear failure of the beam occurred.
For the three concrete strengths, beams cast from dolerite had the highest
shear capacity while beams cast from tillite had less shear capacity than
beams cast from quartzite coarse aggregate. Furthermore, beams cast from 13 mm maximum size coarse aggregate had higher shear capacity than
beams cast from 19 mm aggregate. The conclusion may be drawn that the
type and size of coarse aggregate does influence the shear strength of a
reinforced concrete beam without shear reinforcement.
Description: 
A dissertation submitted in fulfilment of the academic requirements for the degree of Master of Engineering, Durban University of Technology, Durban, South Africa, 2020
URI: https://hdl.handle.net/10321/3659
DOI: https://doi.org/10.51415/10321/3659
Appears in Collections:Theses and dissertations (Engineering and Built Environment)

Files in This Item:
File Description SizeFormat
Jajbhay_2021.pdf5.45 MBAdobe PDFView/Open
Show full item record

Page view(s)

226
checked on Dec 22, 2024

Download(s)

290
checked on Dec 22, 2024

Google ScholarTM

Check

Altmetric

Altmetric


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.