Please use this identifier to cite or link to this item: http://hdl.handle.net/10321/936
Title: Reuse of cured epoxy as a reinforcement in an epoxy composite
Authors: Mohan, T. P. 
Kanny, Krishnan 
Issue Date: 2013
Publisher: Wiley
Source: Mohan, T.P. and Kanny, K. 2013. Reuse of cured epoxy as a reinforcement in an epoxy composite. Polymer Engineering & Science, 53(9): 1839-1844.
Abstract: This article discusses the reuse of a thermoset-based epoxy polymer. In this method, cured epoxy polymer is ground to powder of particle size ranging from 1 to 30 μm. The ground epoxy is then filled in an epoxy polymer to form an epoxy–epoxy composite system using both room and high temperature processing. The amount of filler material was varied from 1 to 10 wt% in the epoxy matrix. Rheology and tensile properties test were then performed. The result shows that the room temperature-processed epoxy composites (above 5 wt% of powders) resulted in the formation of voids, agglomeration of particles, and reduced degree of cure leading to a decrease in tensile properties. These drawbacks (voids, agglomeration, and low degree of cure) were correspondingly absent in composites processed at high temperature. Results from this work suggest that the thermoset polymer can be reused effectively with minimal changes to the unfilled resin properties. POLYM. ENG. SCI., 2013. © 2012 Society of Plastics Engineers
URI: http://hdl.handle.net/10321/936
Appears in Collections:Research Publications (Engineering and Built Environment)

Show full item record

Page view(s) 50

501
checked on Nov 19, 2018

Google ScholarTM

Check


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.